These files are already located in /lib/gluon, no need to add it a second
time.

These files are already located in /lib/gluon, no need to add it a second
time.

gluon-config-mode-domain-select does not have any i18n files of its own.

By emitting Lua code to call translate() and pcdata(), we are more
flexible than when doing this internally in the parser. The performance
penalty should be negligible.

We need a bit less escaping this way.

Also fix all warnings.

Open with O_CLOEXEC, use fstat() instead of stat().

Our strings can be looked up verbatim.

* change type of next_node.name
* create domain entry for each entry and add to dnsmasq configuration

[Matthias Schiffer: reword documentation]

This patch moves the prefix4 subnet route from the local-node veth
device to br-client (while keeping the next node ipv4 address on the
local node device).

This is in preparation to allow routing over the br-client interface
later.

* use local socket
* use main routing table,
* pass client-bridge

This package adds filters to limit the amount of ARP Requests
devices are allowed to send into the mesh. The limits are 6 packets
per minute per client device, by MAC address, and 1 per second per
node in total.

A burst of up to 50 ARP Requests is allowed until the rate-limiting
takes effect (see --limit-burst in the ebtables manpage).

Furthermore, ARP Requests with a target IP already present in the
batman-adv DAT Cache are excluded from the rate-limiting,
both regarding counting and filtering, as batman-adv will respond
locally with no burden for the mesh. Therefore, this limiter
should not affect popular target IPs, like gateways.

However it should mitigate the problem of curious people or
smart devices scanning the whole IP range. Which could create
a significant amount of overhead for all participants so far.

Signed-off-by: Linus Lüssing <linus.luessing@c0d3.blue>

[Matthias Schiffer: slightly clean up code]

Allow returning functions in addition to the names of UCI packages to
commit. Functions are run after all packages have been committed.

Both gluon.sysconfig and libgluonutil already remove the trailing newline
if it exists. It's nicer to avoid files without a trailing newline, e.g.
for printing the file contents in a terminal.

Patch originally authored by @oleeander.

Fixes #424

Allows to remove some redundant UCI lookups.

Fixes #1322