This changes the ath10k firmware and driver selection, as
ath10k-ct is now the default in upstream OpenWrt.

However, for 802.11s operation we need the QCA firmware and driver.

This is necessary, as wpad-basic conflicts with hostapd-mini.

This adds previously absent ath10k packages definitions. This way,
devices correctly select CandelaTech firmware correctly, when
GLUON_WLAN_MESH is set to IBSS.

This is also necessary for all devices, when OpenWrt is switched to
19.07.

fixes #1834
fixes #1332

The OCEDO Koala was missing the correct package definition. Because of
this, firmware is potentially built with the wrong ath10k firmware /
driver.

The kernel partition on these devices is too small for the
OpenWrt 19.07 kernel. It is also located after the rootfs, so
we cannot grow it further.

Therefore mark these devices as deprecated now.

reduce size by removing dispensable packages,
to fix builds of this target in most cases.

This reverts commit fb08e104.

Devices featuring ath10k radios should at least 128 MB of memory
as their driver is quite memory hungry.

Devices with a configuration (1x ath10k, 64M memory) like this have
often been seen as running out of memory.

The profile for GL.iNet AR750 currently selects ATH10K_PACKAGES, but this device actually has a QCA9887 which needs another driver.
This commit fixes the issue by setting ATH10K_PACKAGES_QCA9887 instead.

Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>

memory usage seems to behave more reasonable for a while now

The old bash-based parsing code was way too complex. Replace it with Lua.

This device doesn't have an Ethernet port, and even with the Ethernet
shield, eth0 is not configured.

For some reason, some of the target files were executable.

Signed-off-by: Petr Štetiar <ynezz@true.cz>

Signed-off-by: Jan-Tarek Butt <tarek@ring0.de>

By passing the package name through merge_packages, it becomes possible to
override the package choice in GLUON_SITE_PACKAGES again, for example:

	GLUON_SITE_PACKAGES += -hostapd-mini hostapd

The device is broken until the next release. The LEDs are currently not
working (fixed in current OpenWRT master).

Also give a brief explanation about the BROKEN status being dependent on
the WiFi chip used and not the SoC family in general.

This backports the TP-Link Archer C50 v4.

We are dropping the following upstream commits. They add support for the
TP-Link recovery-flag which enabled the web-recovery. As they are not
needed for the router to work, we drop them for now.

28cd2ca base-files: sysupgrade: support additional mtd options
1e06482 mtd: add logic for TP-Link ramips recovery magic

also added manifest aliases for gl-ar150, gl-ar300m, gl-ar750

This allows for smaller firmware images and makes it possible to reset a
device via firstboot command.

Signed-off-by: Matthias Fritzsche <matthias@chemnitz.freifunk.net>

ath5k supports only IEEE 802.11 a/b/g

Signed-off-by: Matthias Fritzsche <matthias@chemnitz.freifunk.net>

Signed-off-by: Matthias Fritzsche <matthias@chemnitz.freifunk.net>