These devices have never actually existed; the corresponding support
strings have been removed from the stock firmwares as well.

It seems the device was lost during the OpenWrt -> LEDE migration.

This reverts commit fcce9e52.

The x86-generic kernel does not fit into 4MB.

Backport another sysupgrade patch.

Fixes #1130

Updates batman-adv and alfred to 2017.1. This also allows us to drop our
last batman-adv patch.

The staged sysupgrade allows to properly unmount the rootfs before writing
the new partitions. This will fix upgrades losing configuration when
parition sizes change on x86 and similar image types.

This will allow upgrading using the broken sysupgrade scripts in OpenWrt
CC without losing the configuration.

Fixes #1010

Fixes #1126

Reverts d5829d87 ("gluon-mesh-batman-adv-core: disable bridge port
learning on bat0").

Fixes #1121

Don't stop after the first error, as later error messages may make the
cause of the error much clearer in some cases.

The Airgateway LR is the same device as the normal Airgateway but with an detachable antenna. The Pro version is a cheap dual band device.

gluon-core: dns-cache documentation polish
Now its clear that upstreams severs normally means "community gateways".
* added cacheentries to description
* made upstream server description more general
* description of the A and AAAA-records for next_node added
* mention of Cache not being allocated when not set in site.conf 
* dns-cache doku polish

LEDE recently disabled multicast snooping by default:

https://git.lede-project.org/?p=project/netifd.git;a=commitdiff;h=52541140f8138e31958cdc3d7e42a4029fa6bbc9



Reenable it for Gluon as there have been no confirmed issues for
LEDE and no negative reports concerning Gluon v2016.2.x so far.

Closes #1025.

Signed-off-by: Linus Lüssing <linus.luessing@c0d3.blue>

LEDE recently disabled multicast snooping by default:

https://git.lede-project.org/?p=project/netifd.git;a=commitdiff;h=52541140f8138e31958cdc3d7e42a4029fa6bbc9



Reenable it for Gluon as there have been no confirmed issues for
LEDE and no negative reports concerning Gluon v2016.2.x so far.

Closes #1025.

Signed-off-by: Linus Lüssing <linus.luessing@c0d3.blue>

Fixes #1084

Hardware is very similar to Archer C5v1 and C7v2.

Tested factory install and autoupdater.

IBSS Mesh on 2.4 and 5 GHz is working fine.

The only Ethernet Port is used for config mode and afterwards handled
as WAN Port.

We now create bat0 and primary0 independently of the lower mesh interfaces,
making the whole setup a lot more robust. In particular:

- we can't accidentially destroy primary0 because of concurrent setup and
  teardown runs of different interfaces
- bat0 will always exist, even when no mesh interfaces are up (e.g. no link
  on wired mesh)
- interfaces going down and up again will never tear down the whole of
  batman-adv
- we can enable and disable bat0 independently of the lower interface
  states

For simplicity, we don't use different MTUs for compat 14 and 15 anymore,
there's no harm in using 1532 for batman-adv-legacy as well.

In addition, transitive and fixed_mtu now default to 0 instead of an empty string.