Fixes #121

Based-on-patch-by: Tobias Hachmer <tobias@hachmer.de>

Fixes #764

Also backport some patches improving QCA956x support.

Avoid commiting configs inbetween to decrease number of flash writes.

Fixes #714.

This allows to reach the node in setup mode over the same link-local IPv6
address as br-client uses during normal operation.

OpenWrt doesn't set the regdom unless a WLAN device is started. Explicitly set
the regdom in the setup mode to get the correct list of allowed txpower entries
in the planned LuCI module.

This will require site.mk to explicitly pull in the gluon-setup-mode and
gluon-config-mode-core packages.

Moving the scripts to a common directory not only vastly simplifies the
zzz-gluon-upgrade script, but also allows to define an ordering of such
scripts across packages.

By setting setup_mode.skip to true in site.conf the device will skip
setup mode on first boot.

When an early reboot is triggered because an upgrade script has disabled the
config mode, we need to explicitly call /etc/init.d/done, otherwise the overlay
will not be finalized after a firstboot and we get an endless reboot loop.

Since switching to Barrier Breaker/procd, we'd not notice if we were
upgrading from a version before renaming the config file to gluon-setup-mode
as the upgrade scripts run after the preinit.

Fix this by checking later during setup mode init again and rebooting into the
regular run mode if we detect this case.

To start after haveged after the recent update.

gluon-config-mode retains the luci frontend, all setup scripts and config is
moved to the new package.