1. 04 Sep, 2018 1 commit
  2. 03 Sep, 2018 1 commit
  3. 10 Aug, 2018 1 commit
  4. 01 Aug, 2018 1 commit
  5. 25 Jul, 2018 3 commits
  6. 23 Jul, 2018 1 commit
  7. 15 Jul, 2018 3 commits
    • David Bauer's avatar
      ipq40xx: add support for IBSS · c3ceded7
      David Bauer authored
      Add support for IBSS meshing. Leave target marked as BROKEN for IBSS
      as stability is unknown and WiFi LEDs are not working.
      
      Functionality was tested in the network of Freifunk Frankfurt with other
      ipq40xx and ar71xx devices.
      c3ceded7
    • David Bauer's avatar
      ipq40xx: add target · c4b1febd
      David Bauer authored
      This commit adds support for the new ipq40xx target.
      c4b1febd
    • Christoph Krapp's avatar
      ar71xx: add support for TP-Link RE355 (#1478) · 4883bc71
      Christoph Krapp authored
      Support is marked as broken because this device is sold in two variants,
      one with 64M RAM and another with 128M. As of now 64M is not enough
      for ath10k with 5GHz enabled.
      As there is no indication known which variant one will get better mark
      it as broken.
      Signed-off-by: default avatarChristoph Krapp <achterin@googlemail.com>
      4883bc71
  8. 12 Jul, 2018 1 commit
  9. 11 Jul, 2018 2 commits
  10. 10 Jul, 2018 1 commit
  11. 25 Jun, 2018 1 commit
  12. 24 Jun, 2018 1 commit
  13. 22 Jun, 2018 1 commit
  14. 09 Jun, 2018 1 commit
  15. 08 Jun, 2018 1 commit
  16. 07 Jun, 2018 1 commit
  17. 23 May, 2018 1 commit
    • Vincent Wiemann's avatar
      ar71xx: add support for Alfa AP121F (#1404) · 33956cd4
      Vincent Wiemann authored
      Adds support for Alfa AP121F USB powered travel router (looks like an USB ethernet adapter).
      There is no factory image, but only a sysupgrade file for this router which can be installed using the inbuilt UBoot web interface.
      Configure your PC with IP address 192.168.1.2 and connect the router using its RJ45 port. Hold the reset button while powering the device until all LEDs have flashed 3 times simultaneously. You can now access the fallback web interface using a web browser at http://192.168.1.1 and flash the sysupgrade file.
      33956cd4
  18. 17 May, 2018 1 commit
  19. 16 May, 2018 1 commit
  20. 09 May, 2018 1 commit
  21. 08 May, 2018 2 commits
    • Matthias Schiffer's avatar
      ar71xx-generic: make ubiquiti-rocket-m a separate device · 5bd1d88f
      Matthias Schiffer authored
      Make ubiquiti-rocket-m a separate device rather than a bullet-m alias to
      enable USB support and allow adding devive-specific packages.
      5bd1d88f
    • David Bauer's avatar
      ar71xx: add support for Fritz!Box 4020 · 22d45448
      David Bauer authored
      This commit adds support for the AVM Fritz!Box 4020 WiFi-router.
      
      SoC:   Qualcomm Atheros QCA9561 (Dragonfly) 750MHz
      RAM:   Winbond W971GG6KB-25
      FLASH: Macronix MX25L12835F
      WiFi:  QCA9561 b/g/n 3x3 450Mbit/s
      USB:   1x USB 2.0
      IN:    WPS button, WiFi button
      OUT:   Power LED green, Internet LED green, WLAN LED green,
             LAN LED green, INFO LED green, INFO LED red
      UART:  Header Next to Black metal shield
             Pinout is 3.3V - RX - TX - GND (Square Pad is 3.3V)
             The Serial setting is 115200-8-N-1.
      
      Tested and working:
       - Ethernet (LAN + WAN)
       - WiFi (correct MAC)
       - Installation via EVA bootloader
       - OpenWRT sysupgrade
       - Buttons
       - LEDs
      
      Not working:
       - USB port
      
      Installation via EVA:
      In the first seconds after Power is connected, the bootloader will
      listen for FTP connections on 169.254.157.1 (Might also be 192.168.178.1). Firmware can be uploaded
      like following:
      
        ftp> quote USER adam2
        ftp> quote PASS adam2
        ftp> binary
        ftp> debug
        ftp> passive
        ftp> quote MEDIA FLSH
        ftp> put openwrt-sysupgrade.bin mtd1
      
      Note that this procedure might take up to two minutes. After transfer is
      complete you need to powercycle the device to boot OpenWRT.
      Signed-off-by: default avatarDavid Bauer <mail@david-bauer.net>
      22d45448
  22. 06 May, 2018 1 commit
  23. 26 Apr, 2018 3 commits
  24. 13 Apr, 2018 1 commit
    • Matthias Schiffer's avatar
      ar71xx: build kernel modules used by Gluon into the kernel · 02f905f5
      Matthias Schiffer authored
      ar71xx-generic and -tiny benefit most from the optimized kernel, as they
      contain all devices with 32MB RAM. We enable CONFIG_GLUON_SPECIALIZE_KERNEL
      for all targets using the mips24_kc architecture so packages shared between
      targets don't need to be rebuild all the time.
      02f905f5
  25. 10 Apr, 2018 1 commit
  26. 19 Mar, 2018 1 commit
  27. 20 Feb, 2018 1 commit
  28. 07 Feb, 2018 1 commit
  29. 06 Feb, 2018 1 commit
  30. 04 Feb, 2018 1 commit
  31. 03 Feb, 2018 1 commit
    • Matthias Schiffer's avatar
      modules: update LEDE · 87ced3c5
      Matthias Schiffer authored
      b1205a9211 ar71xx: /lib/ar71xx.sh: add model detection for TP-Link TL-WR810N
      fbeae9d891 iptables: make kmod-ipt-debug part of default ALL build
      6ea9a702c5 iptables: Fix target TRACE issue
      00fa1e4108 curl: fix libcurl/mbedtls async interface
      d5278cc48b kernel: bump 4.4 to 4.4.112 for 17.01
      2ae0741f3b dnsmasq: backport validation fix in dnssec security fix
      58d60bd283 dnsmasq: backport dnssec security fix for 17.01
      d626aa005b mountd: bump to git HEAD version
      f0336975be kernel: bump 4.4 to 4.4.111 for 17.01
      fb6f21c657 kmod-sched-cake: bump to latest cake bake for 17.01
      2e8a3bb35f ar71xx: Netgear WNR2000v4: do not include USB packages [17.01]
      3fa86282fa build: fix restoring /etc/opkg with PER_DEVICE_ROOTFS
      987a7e3175 ramips: fix lenovo newifi-y1 switch and LED config
      dbb5ffaed5 ramips: firewrt: indicate boot status via LED
      87ced3c5
  32. 26 Jan, 2018 1 commit